Panadent Dentifix HR PLUS Resins for 3D Printers (1Kg)

171.00 excl. VAT+Carg.

Dreve FotoDent Accessories for 3D Printers 385nm and 405nm

Product price
excl. VAT+Carg.
Additional options total:
excl. VAT+Carg.
Order total:
excl. VAT+Carg.
SKU: 64.01475 Category:

DENTIFIX MODELLING HR (Height Reactive) modelling Resin LCD/DLP (Colour: SAND)

Dentifix Resin was created as a result of collaboration with dental technicians and a renown specialist manufacturer of resin for 3d printers.

DENTIFIX modelling was created for the most affordable dental model of the market!

This resin is perfect for impressions related to Dental applications (Dental models, alignment, contention Gutter, EMI or half dental arcade, crowns, Bridges etc….) It can be used for any other applications requiring a high accuracy of the model.

  • Precision : The resin Dentifix-3d modelling HR allows to print models with a very high level of detail and a precision of up to 35 microns in Z
  • Smooth Surface : With a smooth surface and an almost matte and opaque colour, the Dentifix-3d modelling HT resin is close to traditional gypsum
  • One colour: Carefully defined by dental technicians for more effective work on your models with less fatigue for your eyes.

The colour of this resin has been validated by dental technicians to bring out the details and facilitate laboratory work. The light of the laboratories can greatly strain the eyes when it is reflected on the model during the creation of your dental orthodontics (gutter, ELN, circuit breaker etc…).

The surface state of this resin is very smooth after printing and its hardness allows it to take very important angles to optimise the quality of printing and limit the failures when printing dental models.

You could of course create your dental alignment models with this resin.

Dentifix-3d Modelling product property:

Although the properties of this table are accurate, Dentifix-3d cannot make any warranties, express or implied, as to the accuracy of the properties obtained by using this product.
Product properties may change without notice. 

The use of a primer is recommended.  PLATEBOND MONOCURE 


Dental Modelling


RAL1002 Sand Yellow

Viscosity at 25c

95 MPas


81 Shore D

Exposure Energy

18 MJ/cm2

Max. Cure Depth



0.02-0.085 mm

Tensile Strength

45 MPA

Elongation at break




Additional information






Model (405nm printers) 1Kg, Model 2 (385nm printers) 1Kg, Cast 1kg, Guide 385nm printers 1kg, Guide 405nm printers 1kg, Tray 1kg, Gingiva 385nm 1Kg, FotoDent Setup 385nm/405nm (Maize Yellow) 1Kg


There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.